Popular discussions about programming, compatibility and testing of optical transceivers.
We are wiring an FPGA capture card into an existing server and I am stuck at the very first step: the port simply never comes up. The setup: Mellanox MCX414-GCAT (ConnectX-4 EN, QSFP28, 50GbE capable) in the host FS Q-8LCA020 breakout AOC, QSFP+ on one end, eight LC ends on the other FPGA card on…
A good half of my work is putting one company's optics into another company's switch, so I spend a lot of time asking a module what it thinks it is. My toolbox for that is currently one command deep, and I would like to know what else is worth putting on the bench machine. Linux boxes with SFP+ and…
A FreeNAS box with on-board Intel X552 SFP+ ports (Xeon D) and an ESXi 6.7 host with a Mellanox ConnectX-3 (MT27500, Dell Y3KKR) were cabled with two Mellanox MCP2104-X003B passive DACs from 2014. Looping each device to itself brought the ports up, but between the two systems ESXi showed…
The poster set up several new Cisco Catalyst 9300 switches fitted with C9300-NM-4G network modules, configured GigabitEthernet1/1/1 as a trunk and enabled it, but could not get a link with any of several SFPs. 'show interfaces' reports 'GigabitEthernet1/1/1 is down, line protocol is down…
