CodingBox Q&A Ask question

coaxpilot98

United Kingdom joined 7 months ago 12 questions 13 comments

NOC shift lead from Manchester. Mostly Arista and Mellanox.

Questions

2votes
1 answer
79views

REVELPROG-IS adapters for SFP/SFP+/SFP28/QSFP/QSFP-DD/XFP/OSFP with password brute force and checksum recalculation

Adapter boards that, with a serial programmer, read and write transceiver memory across SFP, SFP+, SFP28, SFP112, QSFP/QSFP+/QSFP28, SFP-DD, QSFP-DD, XFP and OSFP. The software covers the MSA/CMIS memory maps, manages host/manufacturer passwords including brute-force search, changes…

0votes
1comment
85views

SFP Access Port: RP2040-based open hardware to read and write SFP/SFP+ embedded EEPROM over USB

An open hardware/firmware project to read and write the EEPROM inside SFP and SFP+ modules so their capailities and vendor origin can be inspected and modified. It uses an RP2040 microcontroller and exposes a USB Mass Storage interface. The project is a work in progress and does not yet document…

3votes
2comments
92views

Baudcom GPON ONU SFP stick in a MikroTik hEX S registers on the OLT but the SFP WAN interface cannot route

Replacing the ISP ONU with a Baudcom DB-1234-SFM GPON SFP stick in a hEX S: the stick registered with the OLT and obtained an IP with the spoofed MAC, but with sfp1 as WAN pings returned network unreachable, although the same configuration on ether1 (behind the ISP ONU) worked and Winbox showed no…

1vote
2comments
108views

Diagnosing a ConnectX-4 port with link but no traffic and 25G optics negotiating only 1G on a MikroTik switch

With two dual-port Mellanox ConnectX-4 cards, a MikroTik SFP+ switch, 1 m OM4 patches and mixed 10G/25G transceivers from several vendors, one NIC port showed link UP but got no DHCP and could not route, 25G transceivers negotiated only 1G, and previously stable 10G links dropped intermittently…

1vote
1comment
129views

ethtool -m on a Mellanox MT26448 (ConnectX-2) returns Input/output error: DOM readout not supported on EOL adapters

On Debian 8.11 (kernel 3.16) the poster ran ethtool -m on a Mellanox MT26448 adapter to read optical diagnostics (TX/RX power, temperature, voltage, thresholds) and got Cannot get module EEPROM information: Input/output error. Hardware involved: Mellanox MT26448 ConnectX-2, SFP+ optic with DDM…

0votes
1 answer
165views

Brocade ICX6450-C12-PD SFP ports stay down: the C12 only does 1G while the peer ICX6450-24P defaults to 10G

The two SFP ports (F1/F2) of a Brocade ICX6450-C12-PD, licnesed for 10G, would not come up with either a Brocade 1000BASE-LR SFP (33211-100) or 10GBASE-SR moduls over a 5 m single-mode patch to an ICX6450-24P. show media saw the transceivers but the interface reported GigabitEthernet1/3/1 is down…