Extreme EXOS: supported, unsupported, restricted and unrestricted optics
How do I check whether an optic is supported in Extreme Switch Engine (EXOS) and what do the classes mean?
NOC shift lead from Valencia. Mostly PON and GPON.
How do I check whether an optic is supported in Extreme Switch Engine (EXOS) and what do the classes mean?
Can third-party 100GbE DACs connect QFX5200-32C switches to an all-flash storage array without a vendor block? Which EEPROM compatibility and exact-pairing checks are needed before production use?
Can an Alcatel-Lucent G-010S-P GPON SFP ONT be used directly in the SFP WAN port of a TP-Link ER7206 V2? The SFP LED lights but the WAN address remains 0.0.0.0. Which stick-managemnt, bridge-mode and provider-authentication sttings need checking?
On a PA-5450 the 40/100G QSFP ports 1/25 and 1/26 power down and nothing appears in the logs after a breakout cable is plugged in. Is the port or the transceiver dead?
What constraints apply to direct attach copper cables and transceivers on NetScaler MPX appliances such as the MPX 14000 with its sixteen 10G SFP+ ports, and why does a DAC sometimes refuse to link or break a link aggregation channel?
We are a small regional ISP rebuilding the optics budget for next year. Every 10G spare on our shelf is coded for exactly one platform, so the spares pool is roughly three times larger than our failure rate justifies. The idea on the table is to buy re-codable modules and code them ourselves as…
Replacing a customer's incumbent aggregation pair with CloudEngine kit, and the single link that refuses to come up is the 100GE feed into their packet broker. Everything else on the switch went in without drama. Huawei CloudEngine 6800, 100GE port 100GBASE-SR4 QSFP28 modules, Huawei parts, one at…
Two SRX1500 sit in separate data centres a few kilometres apart, joined by dark fiber pairs we own end to end. They have to come up as a chassis cluster, which means the control link has to cross that fiber instead of a patch cord inside one rack. The setup: two Juniper SRX1500, identical hardware…
Small office, one leased line, and the carrier terminated it on an ADVA FSP150CP screwed to the wall of the comms cupboard. My job is to get our own router onto that circuit instead of renting one from them, so the ix0 SFP+ port of a Netgate XG-7100 goes straight ino the ADVA access port. Netgate…
Four HP A5500-HI switches in an IRF stack logged unsupported transceiver messages for six rear-module (JD368B) ports that were cabled with HP J9281B SFP+ DACs to ProLiant Gen8 servers with 530SFP+ NICs. display transceiver interface shwed Transceiver Type STACKSFPPLUS, Connector COPPER, Vendor Name…
I run pfSense on a small box with a Chelsio T580 and I want one of the QSFP+ ports feeding four 10G hosts instead of a single 40G link. The breakout cable is still on its way, so I would rather have the card in the right mode before it lands. pfSense box, Chelsio T580, one QSFP+ port sitting on a…
The thread starter wanted to reprogram GBIC and SFP module EEPROMs but found that guides were disappearing from forums. Questions covered which programmer to use, where to attach the I2C lines on the module, whether the module needs 5 V (GBIC) or 3.3 V (SFP), and how to treat the memory as a…