A UCS 6332 fabric interconnect has only 40G QSFP+ ports, but the upstream switches are 10G. How can the FI be uplinked at 10G, and why does the breakout option not appear on some ports?
On an Extreme Summit X670 two QSFP+ ports were configured as 4x10G, the ports were set to 10000 full duplex with auto off and VLANs assigned, but a breakout cable with an MPO connector to six LC connectors produced no link on the QSFP+ sie or on the SFP+ side. Hardware involved: Extreme Summit…
The poster wanted to use a QSFP+ 40G-to-4x10G breakout cable on a two-port Mellanox ConnectX-3 Pro (MT27520, firmware 2.42.5044, PSID HP1370110017, MLNX OFED 4.6 on Debian 9.6) so each 10G leg could connect to a different switch, similar to what an Intel XL710 offers. SR-IOV virtual functions had…
We are wiring an FPGA capture card into an existing server and I am stuck at the very first step: the port simply never comes up. The setup: Mellanox MCX414-GCAT (ConnectX-4 EN, QSFP28, 50GbE capable) in the host FS Q-8LCA020 breakout AOC, QSFP+ on one end, eight LC ends on the other FPGA card on…
Mellanox-branded Q-4S28AO03 3 m QSFP28 AOC 1x4 breakout cables (100G with FEC) that worked under Onyx 3.9.1908 stopped linking after an upgrade to Onyx 3.10.x. The ports reported Cable speed not enabled and, with auto speed, Negotiation failure; supported speeds showed 1G/10G/25G but the actual…
Speccing the uplinks for an M4300-96X before the order goes in, and the 40G side has turned into a dead end that I would like to sanity check with people who have actually built one. NETGEAR M4300-96X chassis APM402XL port card for the 40G QSFP+ ports planned: two 40GBASE-X runs to the neighbouring…
We are building out two racks and the switching is settled: a pair of M4500-48XF8C as the leaves with M4350 underneath. What is not settled is the optics BOM. NETGEAR does not put its own label on 25G or 100G modules, and I would rather not discover after delivery that the SFP28 ports dislike what…
I run pfSense on a small box with a Chelsio T580 and I want one of the QSFP+ ports feeding four 10G hosts instead of a single 40G link. The breakout cable is still on its way, so I would rather have the card in the right mode before it lands. pfSense box, Chelsio T580, one QSFP+ port sitting on a…
We are standing up four DGX Spark nodes for disttributed training and hung them off a MikroTik CRS812-8DS-2DQ-2DDQ. The plan was one 400G QSFP-DD port on the switch feeding two nodes at 200G each, so a couple of breakout cables cover the whole cluster. MikroTik CRS812-8DS-2DQ-2DDQ, QSFP-DD ports…
The poster wanted to use a 40G QSFP+ to 4x10G SFP+ DAC breakout cable on a Cisco Catalyst 9500-32QC-E running IOS XE 17.6.4 (Bengaluru). The 'hw-module breakout' command is rejected; in global configuration only 'hw-module slot' and 'hw-module subslot' are offered. The switch is not running…
