CodingBox Q&A Ask question

lambdaeng12

Vietnam joined 1 year ago 7 questions 21 comments

Storage/SAN admin from Da Nang. Mostly FS and generic modules.

Questions

3votes
2comments
54views

EX4300 4x1G/10G uplink card: link down with RX -40 dBm because the far end uses a 1G SFP against a 10G SFP+

An EX4300 got a 4x 1G/10G SFP/SFP+ uplink card and a 10G SFP+ module, but no fiber link comes up. Does the card have to be enabled somehow? After configuring xe-0/2/3 into a LAG, the interface still shows 'Physical link is Down' and 'show interfaces diagnostics optics' reports receiver powwer…

2votes
2comments
51views

ConnectX-4 Lx MCX4121A-ACAT advertises only 10000baseKR: link to a 10GBASE-R device passes no traffic until firmware 14.30.1004

A ConnectX-4 Lx EN MCX4121A-ACAT (25GbE dual SFP28, firmware 14.27.1016) on Linux Mint 19.3 / kernel 5.4 is connected to equipment that only speaks 10GBASE-R variants (SR/CR, no KR). A link comes up but no data is transmitted or received. ethtool lists 10000baseKR/Full as the only 10G mode next to…

4votes
1 answer
182views

EX4200 reports the SFP+ EEPROM as mis-programmed after a Junos upgrade while an MX960 still shows DOM

We run a handful of 80 km DWDM spans off EX4200s with third-party optics on both ends, because the vendor-branded DWDM parts were never going to fit the budget. That was fine for years. After the EX boxes were moved to Junos 12.3 the optics still sit in the same ports and the spans still exist, but…

Vietnam lambdaeng12 VN asked