CodingBox Q&A Ask question

Questions tagged “rx-power”

5 questions
15 30 50 per page
3votes
2comments
54views

EX4300 4x1G/10G uplink card: link down with RX -40 dBm because the far end uses a 1G SFP against a 10G SFP+

An EX4300 got a 4x 1G/10G SFP/SFP+ uplink card and a 10G SFP+ module, but no fiber link comes up. Does the card have to be enabled somehow? After configuring xe-0/2/3 into a LAG, the interface still shows 'Physical link is Down' and 'show interfaces diagnostics optics' reports receiver powwer…

5votes
4comments
203views

27 km span on an MES3324F: the same modules link up in an MXA-64 but Eltex takes the port to PORT_SUSPENDED

A link between two of our sites: about 27 km of single-mode fiber, MES3324F on both ends. Installed a pair of 1550 nm FANG HANG SFPs sold as 40-km modules. The link comes up, lives for a few dozen seconds, and drops, over and over, until the port gets blocked. 2 x Eltex MES3324F, firmware 4.0.7 SFP…