CodingBox Q&A Ask question

fiberwolf

France joined 1 year ago 9 questions 14 comments

Optical transport specialist from Lyon. Mostly ISP backbone.

Questions

1vote
1comment
73views

SFP Doctor: open hardware/software to read and rewrite SFP OUI and identity when write access is not locked

An open-source hardware and software project to read and modify SFP/SFP+ EEPROM, aimed at changing the OUI and other identity fields so a module works with third-party transceivers where the vendor has not fully disabled write access. It uses a Cypress CY8CKIT-059 board as the USB interface. As of…

4votes
2comments
152views

Zyxel XGS4600 SFP+ modules randomly stop transmitting after firmware 4.50; DDM shows TX power -inf and 0 mA bias

On Zyxel XGS4600 switches, 10G and 1G SFP+ transceivers (including an FS.com DWDM-SFP10G-80) intermittently stopped transmitting; only removing and reinserting the module restored the link. Transceiver statistics at that moment showed TX power -inf dBm, voltage at the 3.00 V low alarm and TX bias…

France fiberwolf FR asked
2votes
1 answer
55views

pfSense on an 82599 (X520 clone) cannot negotiate 2.5G with an SFP+ RJ45 module to a cable modem

A pfSense router on a Supermicro R210 II with an AOC-STGN-i2S (82599-based X520 clone) was connected throguh an FS.com SFP+-to-RJ45 module to a cable modem with a 2.5 Gbps port. No link negotiation happened; pfSense offered only auto and 10G speeds and never 2.5G. Hardware involved: Supermicro…

4votes
1 answer
43views

On-board ConnectX-3 shows no link with a QSFP-to-SFP+ adapter plus SFP+ optic; Mellanox hybrid cable fixes it

Intel-branded servers witth a built-in ConnectX-3 (MT27500, ConnectX3-A1-WSP-QDR, firmware 2.36.5000, mlx4en 4.6, kernel 4.19.68) lost link when a QSFP-to-SFP+ adapter with an SFP+ transceiver replaced direct QSFP cabling: ethtool reported Link detected: no and speed Unknown!, port in ETH moe. The…