Cisco MDS 9000: isolating FC SFP and cable problems with transceiver details and error counters
Asked Active Viewed 65 Original language: English
2
How to determine whether an unstable or faliing FC lnik on an MDS 9500/9700 (for example on a DS-X9248-256K9 line card) is caused by the SFP, the fiber, its length or a patch panel?
Read show interface fcX/Y transceiver details for the module's supported reach and actual DOM thresholds. Compare the installed fibre type and route length with those values rather than using a generic dBm range.
Watch CRC and corrected/uncorrected FEC counters under traffic, then bypass patch panels and swap one cable or optic at a time. Repeating the same measurement after each change gives more useful evidence than an idle link LED.
Comments 2
Read
show interface fcX/Y transceiver detailsfor the module's supported reach and actual DOM thresholds. Compare the installed fibre type and route length with those values rather than using a generic dBm range.Watch CRC and corrected/uncorrected FEC counters under traffic, then bypass patch panels and swap one cable or optic at a time. Repeating the same measurement after each change gives more useful evidence than an idle link LED.