CodingBox Q&A Ask question

xl710-unlocker: X710/XL710 NVM을 패치해서 어댑터가 non-Intel SFP 모듈을 받아들이게 하기

Asked Active Viewed 135 AI translation from English
0

Intel X710/XL710 어댑터는 펌웨어 레벨에서 서드파티 광모듈을 Rx/Tx is disabled on this device because an unsupported SFP module type was detected라는 메시지와 함께 거부하고, i40e 드라이버에는 이를 우회할 옵션이 없습니다. 해당 저장소에는 이 체크를 제거하는 절차가 문서화되어 있습니다: 검증된 펌웨어로 업데이트(9.10으로 테스트됨)하고, 작은 C 도구로 어댑터 EEPROM을 덤프하고, 0x6800-0x7000 영역에서 마커 패턴(000b)을 찾고, 그 마커에서 고정된 오프셋만큼 떨어진 곳에서 모듈 검증을 담당하는 동일한 레지스터 4개를 찾은 다음, 두 번째 도구로 그 값을 다시 쓰고 재부팅합니다. X710-DA2 카드에서 검증됐습니다.

  • Hardware: Intel X710-DA2, Intel XL710
  • Transceivers: non-Intel SFP+ 모듈
  • Form factor: SFP+, QSFP+

증상 / 메시지:

Rx/Tx is disabled on this device because an unsupported SFP module type was detected

Comments 1

Accepted answer

스캔 도구를 빌드하고, EEPROM을 덤프하고, 000b 마커 근처의 검증 레지스터 4개를 찾아낸 다음, write 도구로 패치하고 재부팅하세요. 그러면 이후로는 어떤 SFP 모듈도 받아들여집니다. 오프셋을 잘못 잡으면 NVM이 벽돌이 될 수 있으니 먼저 백업하세요.

1 South KoreanetrunnerKR Show original (English) AI translation
Log in to comment. Log in