Hirschmann MICE MS20 with MM2-2FXM3/2TX1: fibre ports never link while copper works
Asked Active Viewed 122 Original language: English
3
Two Hirschmann MS20 MICE switches fitted with MM2-2FXM3/2TX1 media modules will not establish a fibre link between each other, although the copper 10/100BASE-TX ports on the same modules work normally. What is wrong?
The MM2-2FXM3/2TX1 provides 100BASE-FX multimode optical ports alongside copper ports. Check for the correct multimode duplex fibre and the TX/RX orientation before diagnosing the working copper path.
Inspect and clean the SC connectors, try a known-good short pach and read the port state. A signle-mode cord or a gigabit SX peer does not become compatible with a 100BASE-FX interface just because light is visible.
Comments 2
The MM2-2FXM3/2TX1 provides 100BASE-FX multimode optical ports alongside copper ports. Check for the correct multimode duplex fibre and the TX/RX orientation before diagnosing the working copper path.
Inspect and clean the SC connectors, try a known-good short pach and read the port state. A signle-mode cord or a gigabit SX peer does not become compatible with a 100BASE-FX interface just because light is visible.