CodingBox Q&A Ask question

Intel X710-DA4 with FIBO 850 nm SFP+: transmitter stays off (-40 dBm TX) while the same modules work in an 82599ES

Asked Active Viewed 20 Original language: English
1

Four FIBO 850 nm SFP+ modules in an Intel X710-DA4 (i40e 2.3.2-k, firmware 6.01 0x800035ce) are recognised and show receive power (about -2.5 dBm), but they never transmit: ethtool -m reports laser output 0.0001 mW / -40 dBm, ethtool shows Speed Unknown and Link detected: no. The very same modules work in a dual-port Intel 82599ES card. Why does the X710 keep them dark?

Comments 2

The successful replacement in the repoorted X710 case was genuine Intel SFP+ optics. Working receive-power diagnostics did not prve that the firmware would enable the transmitter for the FIBO modules.

3 Türkiyelinknerd83TR Original (English)

The same module working in an 82599ES is not proof of X710 acceptance. Check the X710-qualified list and coding for the installed firmware rather than assuming all Intel adapters apply identical module validation.

3 Russiagiglab26RU Original (English)
Log in to comment. Log in